Electrical Information - Holzstar DB900 Instruction Manual

Electrical information

Guidelines for using extension cords
WARNING! THIS WOOD LATHE IS FOR INDOOR USE ONLY. DO NOT EXPOSE TO RAIN
OR USE IN DAMP LOCATIONS.
Make sure your extension cord is in good condition. When using an extension cord, be sure to
use one heavy enough to carry the current your product will draw. An undersized cord will cause
a drop in line voltage resulting in loss of power and overheating. The table below shows the
correct size to use according to cord length and nameplate ampere rating. If in doubt, use the
next heavier gauge.
Extension lead sizes shown assure a voltage drop of not more than 5% at rated load of
tool.
Ampere rating
(on name plate)
Extension cable length
7.5m
15m
22.5m
30m
45m
WARNING! THIS TOOL MUST BE GROUNDED WHILE IN USE TO PROTECT THE
OPERATOR FROM ELECTRICAL SHOCK.
SAVE THESE SAFETY RULES!
Assembly
Unpacking (Fig 1)
1. Carefully remove the leg set and wood lathe from the carton.
CAUTION! THE WOOD LATHE IS VERY HEAVY AND MUST BE LIFTED WITH THE HELP OF
2 PEOPLE OR MORE. THE ASSEMBLY PROCESS REQUIRES 2 PEOPLE OR MORE TO
SAFETY ASSEMBLE THE LATHE TO THE LEG SET.
2. Separate the parts for the leg set from the parts of the lathe.
3. Lay out all parts and check them against the parts listed below. Examine all parts carefully.
3 6
Wire size mm²
0.75 0.75
0.75 0.75
0.75 0.75
0.75 0.75
0.75 1.25
10
1.0
1.0
1.0
1.25
1.5
13
1.25
1.5
1.5
1.5
2.5
４