Assembly - Holzstar DB900 Instruction Manual

WARNING! IF ANY PART IS MISSING OR DAMAGED, DO NOT PLUG THE WOOD LATHE IN
UNTIL YOU HAVE REPLACED THE MISSING OR DAMAGED PART.
For you satiety, complete the assembly of the lathe before plugging it into the power supply.

Assembly

Leg Set Assembly
Attach one front leg and one back leg (1) to the outside edges of the top
q
plate (2) using carriage bolts (3), washers (4) and nuts (5). The top plate
(2) should fit inside the legs (1). Do not tighten nuts at this time.
Repeat this procedure for the remaining legs and top plate.
q
Attach the long plate (6) to the legs using carriage bolts, washers and
q
nuts.
Place the leg stand on a level surface and tighten all nuts securely using
q
a 14mm wrench.
Fig 2
1. Lathe bed assembly
2. Face plate
3. Headstock spur center
4. Tailstock cup center
5. Push rod
6. Flat wrench
7. Hex key
8. Instruction manual
9. Hex bolt and nut
10. Stand
11. Handle
12. Extension bed
５