Table of Contents
Advertisement
1. Introduction
1.1
General Specifications for Standard Lifts
Roll-Over Capacity
(fully lowered)
10,000 Lb.
1.2
Responsibilities of Owner and Users
Basic Principles - Owners/users shall apply sound principles of safety, training, inspection,
maintenance, and expected operating environment. It shall be the responsibility of the owner/user
to advise the manufacturer where deflection may be critical to the application.
Manuals - Owners/users shall keep and maintain a copy of the operating and maintenance
manual(s) and ensure its availability to operating and maintenance personnel.
Inspection and Maintenance - It shall be the responsibility of the users to inspect and maintain
the industrial scissors lift as required to ensure proper operation. The frequency of inspection
and maintenance shall be based upon the manufacturer's recommendations and be compatible
with operating conditions and the severity of the operating environment. Machinery that is not in
proper operating condition shall be immediately removed from service until repaired. Maintenance
and repairs shall be made by a qualified person and the repairs shall be in conformance with the
manufacturer's recommendations.
Maintenance Safety Precautions - Before adjustments and repairs are started on the machine,
the following precautions shall be taken as applicable:
1. Remove the load from the load enclosure.
2. Lower the platform to the full down position.
3. Relieve system pressure from all circuits before loosening or removing any components.
4. All controls in the "off' position and all operating features secured from inadvertent motion
by brakes, blocks, or other means.
5. Disconnect power and follow established owner/user lockout/tag out policies.
6. Follow precautions and directions as specified by the manufacturer.
Replacement Parts - When parts or components are replaced, they shall be replaced with parts
or components approved by the original manufacturer.
Maintenance Training - The user shall ensure only qualified personnel inspect and maintain the
machine in accordance with the manufacturers recommendations.
Operator Training - An owner/user, who directs or authorizes an individual to operate the
machine shall ensure that the individual has been:
1. Trained in accordance with the manufacturer's operating manual.
2. Made aware of the responsibilities of operators as outlined in section 1.4 of this manual.
3. Retrained, if necessary, based on the owners/user's observation and evaluation of the
operator.
Presto Lifts
Vertical
Low
Travel
Height
59"
8"
Model
Lift Capacity
PDL60-50
5,000 Lb.
DDL60-60
6,000 Lb.
PDL60-80
8,000 Lb.
Throw-Over
Standard
Plate
Platform
18" x 60"
6' x 8'
Rise Time Approx. Weight
27 sec.
27 sec.
Up to 4000 Lb.
42 sec.
4
Maximum
Motor
Platform
8' x 10'
3.2 HP
PDL Manual
Advertisement
Table of Contents
