Presto Lifts ECOA PDL60-50 Owner's Manual page 14

6. Once the platform has been raised and the maintenance chocks have been engaged,
verify the pins at the base of the hydraulic cylinders are properly seated.
7. Ensure the machine is level. If necessary use shims beneath the lag plates. All load
bearing points of the base frame must be fully supported by using grout beneath the base
frame.
8. Anchor the machine using appropriate anchors.
Presto Lifts
An improperly supported base frame can cause excess wear and/or
permanent damage to the machine.
LAG PLATES (ALL
FOUR CORNERS)
ROLLER TRACKS (BOTH SIDES)
SIDE ROLL-OVER
SUPPORT (BOTH SIDES)
CROSS HATCHING INDICATES AREAS THAT
NEED TO BE SHIMMED AND/OR GROUTED,
ONCE LEVELED.
VERIFY CYLINDERS ARE
PROPERLY SEATED AFTER
MANUALLY RAISING THE
PLATFORM
FRONT ROLL-OVER SUPPORT
HINGE END
14
PDL Manual