Disassembly Procedure - Mitsubishi Electric City Multi PLFY Series Technical & Service Manual

9

DISASSEMBLY PROCEDURE

PLFY-P15VFM-E1R1.TH
PLFY-P32VFM-E1R1.TH
OPERATING PROCEDURE
1. Removing the air intake grille and air filter
(1) Slide the knob of air intake grille to the direction of the
arrow 1 to open the air intake grille.
(2) Remove the grille hook from the panel to prevent the
grille from dropping.
(3) Slide the hinge of the intake grille to the direction of the
arrow 2 and remove the air filter.
2. Removing the panel
(1) Remove the air intake grille. (Refer to procedure 1)
Connector box (See Figure 1)
(2) Remove the screw of the connector cover.
(3) Slide the connector cover to the direction of the arrow to
open the cover.
(4) Disconnect all the connectors, then pull out the connec-
tors that are coming from panel side from the connector
box.
Corner panel (See Figure 2 and Photo 2)
(5) Loosen the screw from the corner of the corner panel.
(6) Slide the corner panel as indicated by the arrow.
(7) Remove the safety wire from the hook, then remove the
corner panel from the panel.
(The safety wire is not equipped for the signal receiver
panel and i-see Sensor corner panel.)
(8) Remove the fastener (*), then remove the corner panel.
Panel (See Photo 3)
(9) Remove the 4 screws.
(10) Unlatch the 2 hooks.
* Fastener is only for the signal receiver and i-see Sensor corner
panel.
TCH061
TCH061.indd 26 TCH061.indd 26
PLFY-P20VFM-E1R1.TH
PLFY-P40VFM-E1R1.TH
Photo 1
Air intake grille
Air intake grille knobs
Figure 1
Connector
box
Figure 2
Photo 2
Photo 3
26
PLFY-P25VFM-E1R1.TH
PLFY-P50VFM-E1R1.TH
Be careful when removing heavy parts.
PHOTOS/FIGURES
1
1
Grille
Screw
Fastener*
Connector cover
Screw
Corner panel
Safety wire
Screws
Hook
Screws
Grille hook
Air filter
2
Fastener*
Grille
Hook
Turbo fan
Nut and square
washer or nut
and washer
Hook
24/6/2564 16:46:02 24/6/2564 16:46:02