Table of Contents
Advertisement
5.2) Command with safety devices deactivated
The movement of the motor during the down manoeuvre is inhibited by an obstacle. The automation can in any case be
manoeuvred in emergencies by means of the following procedure:
• After a command the motor does not move because a safety device is active (photocell triggered or sensitive edge pushed)
• Within 2 seconds activate the command and keep it activated.
• After 2 seconds the motor will start moving in the "hold to run control" mode so long as the control is maintained the motor
will keep moving; as soon as the control is released the motor will stop.
5.3) Disconnection of the F210S photocell from the automation
When the F210S photocell is installed it is memorised in the motor or in the control unit to which it is connected.
The following must be performed if the photocell needs to be permanently disconnected from the system:
With the F210S photocell connected and the power supply on, remove jumper JP1 from the RX, the DL2 LED will begin to rap-
idly flash. At this point turn off the power supply and disconnect the F210S photocell from the TTBUS.
At the next activation, the motor or control unit will behave as if the photocell had never been connected.
6) Maintenance
The F210S does not require any particular maintenance, however a control should be performed at least once every six months
to check the integrity of F210S (presence of dampness, rust, etc), cleaning of the external casing and testing as described in
chapter 4 "Testing". F210S photocells have been designed to function under normal conditions for at least 10 years, therefore
maintenance should be performed more frequently once this period has expired.
7) Disposal
As for the installation, the disposal of the product at the end of its effective life, must be performed
by qualified personnel.
This product is made of various types of materials, some of which can be recycled while others
must be disposed of. Enquire about the recycling or disposal systems available for this product
category in compliance with regulations locally in force.
!
Some parts of the product may contain polluting or hazardous substances that, if incorrectly disposed of, could
have a damaging effect on the environment or on the health of individuals.
As indicated by the symbol in figure 16, this product must not be disposed of in household waste. Perform "separated collec-
tion" for disposal in compliance with regulations locally in force, or return the product to the manufacturer when purchasing a
replacement.
Heavy fines may be imposed by local laws for the illegal disposal of this product.
16
8
Advertisement
Table of Contents
