Troubleshooting; Fault Table - Stiga SWP 335 Operator's Manual

SWP 355

8. Troubleshooting

WARNING
Risk of cutting due to broken glass, metal
or other sharp edged materials!
When emptying the sweeping container,
cutting injuries may occur due to broken glass,
metal or other sharp edged materials.
• Wear the prescribed personal protective
equipment!
CAUTION
Health impairments caused by dust
resulting from sweeping!
The inhalation of dusts can endanger the
health.
• Wear the prescribed personal protective
equipment!
CAUTION
Risk of injury through tipping over of the
telescopic bracket!
Tipping over of the telescopic bracket may
lead to slight injuries, such as jamming of
the finger or haematomas in users or other
persons.
• When carrying the device, hold it so that the
telescopic bracket cannot tip over.
Even if the prescribed maintenance work and
checks of the device before use are complied
with, faults may occur. Possible faults are listed
in the table below, with specification of the cause
and remedy.
8.1 Fault table
Fault
Device is
running with
difficulty or
roughly
Bristles are
bent
Sweeping
result is
insufficient
Autogoods "130"
Troubleshooting
Cause Remedy
Device is Clean device, see
contaminated Section
Broom blocked Remove blockage see
Section "Remove
blockage"
Contaminated Clean broom drives, see
broom drives Section "Clean device"
Set height adjustment,
Height
adjustment see Section in the
is set too section "Adjust height
low, contact setting"
pressure of the
plate brooms
too high
Plate brooms do Contact Service
not rotate
Improper Align the bristles, see
storage Section in the section
"Align bristles"
Sweeping lip is Replace sweeping lip
missing, loose
or worn
EN
65