Mitsubishi Electric A800 Instruction Manual page 83

Check and clear of the faults history
Faults history clearing procedure
POINT POINT
• Set Err.CL Fault history clear = "1" to clear the faults history.
Screen at power-ON
1.
The monitor display appears.
Parameter setting mode
2.
Press to choose the parameter setting mode. (The parameter number read previously appears.)
Selecting the parameter number
3.
Turn until "
appears.
Faults history clear
Turn to change the set value to "
" " and "
4.
82
PROTECTIVE FUNCTIONS
Operation
" (faults history clear) appears. Press
". Press
" blink alternately after parameters are cleared.
•Turn to read another parameter.
•Press to show the setting again.
•Press twice to show the next parameter.
to read the present set value. "
to start clear.
" (initial value)