Table of Contents
Advertisement
Routing
Routing tables allow you to determine which physical interface address to use for outgoing IP data. If you have more than one
determine which physical interface address to use for outgoing IP data. If you have more than one
determine which physical interface address to use for outgoing IP data. If you have more than one
router and subnet, you will need to configure the routing table to allow packets to find the proper routing path and allow di
router and subnet, you will need to configure the routing table to allow packets to find the proper routing path and allow different
router and subnet, you will need to configure the routing table to allow packets to find the proper routing path and allow di
subnets to communicate with each other.
These settings are used to setup the static and dynamic routing features of the NF5.
These settings are used to setup the static and dynamic routing features of the
Dynamic Routing:
Dynamic Routing:
Dynamic Routing:
Dynamic Routing:
Routing Information Protocol (RIP) will exchange information about different host destinations for working out routes throughout
Routing Information Protocol (RIP) will exchange information about different host destinations for working out
Routing Information Protocol (RIP) will exchange information about different host destinations for working out
the network.
Note: Only select RIPv2 if you have a different subnet in your network. Otherwise, select RIPv1.
nly select RIPv2 if you have a different subnet in your network. Otherwise, select RIPv1.
nly select RIPv2 if you have a different subnet in your network. Otherwise, select RIPv1.
Static Routing:
Static Routing:
Static Routing:
Static Routing:
For static routing, you can specify up to 8 routing rules.
For static routing, you can specify up to 8 routing rules.
You need to enter the destination IP address
destination IP address
destination IP address
destination IP address, subnet mask
destination IP address
destination IP address
destination IP address
destination IP address
selecting the Enable
Enable checkbox.
Enable
Enable
Click the Save
Save
Save
Save button to store your setting or
to store your setting or the Undo
www.netcommwireless.com
All manuals and user guides at all-guides.com
subnet mask, gateway
subnet mask
subnet mask
gateway, and hop
gateway
gateway
Undo button to discard your changes.
Undo
Undo
hop
hop for each routing rule, then enable the rule by
hop
for each routing rule, then enable the rule by
NetComm Wireless NF5 User Guide
48
Advertisement
Table of Contents
