Table of Contents
Advertisement
SNMP
SNMP (Simple Network Management Protocol) is a protocol designed to give a user the capability to remotely manage a
SNMP (Simple Network Management Protocol) is a protocol designed to give a user the capability to remotely manage a
SNMP (Simple Network Management Protocol) is a protocol designed to give a user the capability to remotely manage a
computer network by polling and setting terminal values and monitoring network events.
computer network by polling and setting terminal values and monitoring network events.
OPTION
You must check Local, Remote or both to enable SNMP function. If Local is checked, this device will only respond to requests
You must check Local, Remote or both to enable SNMP function. If Local is checked, this device will only respond to requests
You must check Local, Remote or both to enable SNMP function. If Local is checked, this device will only respond to requests
Enable SNMP
from LAN connected hosts. If Remote is checked, this device will respond to requests from the WAN connection.
from LAN connected hosts. If Remote is checked, this device will respond to requests from the WAN connection.
from LAN connected hosts. If Remote is checked, this device will respond to requests from the WAN connection.
Get Community
Sets the community string your device will respond to for Read-Only access.
Sets the community string your device will respond to for Read
Set Community
Sets the community string your device will respond to for Read/Write access.
Sets the community string your device will respond to for Read/Write access.
Input your SNMP Management host IP here. You will need to
Input your SNMP Management host IP here. You will need to configure the address where the device should send SNMP Trap
IP 1, IP 2, IP 3, IP 4
messages to.
SNMP Version
Please select proper SNMP Version that your SNMP Management software supports.
Please select proper SNMP Version that your SNMP Management software supports.
WAN Access IP Address
You can limit remote access to a specific IP address by entering it here.
You can limit remote access to a specific IP address by entering
Note: If "Remote" access is enabled, the default setting of 0.0.0.0 means any IP obtain SNMP protocol Information.
If "Remote" access is enabled, the default setting of 0.0.0.0 means any IP obtain SNMP protocol Information.
If "Remote" access is enabled, the default setting of 0.0.0.0 means any IP obtain SNMP protocol Information.
Click the Save
Save
Save
Save button to store your setting or
to store your setting or the Undo
NetComm Wireless NF5 User Guide
47
All manuals and user guides at all-guides.com
Undo button to discard your changes.
Undo
Undo
DEFINITION
configure the address where the device should send SNMP Trap
www.netcommwireless.com
Advertisement
Table of Contents
