BrewBuilt X1 UNI Assembly And Instruction Manual page 8

2. Attach your CO tank to the gas-in post on your Pressure Pack lid and set it to around 10–12 psi.
2
3. Attach the Corny Keg Ball Lock Jumper Line to the bev-out post on your Pressure Pack lid.
4. Once you hook up the bev-out to the keg, beer will start flowing from the pressurized X1 Unitank into the unpressurized keg.
5. Once your beer has transferred, unhook the bev-out and gas-in connectors. Pressurize your keg.
6. Be sure to release any pressure from inside your X1 before opening it for cleaning.
FERMENTING UNDER PRESSURE
WARNING: Follow all special warnings and instructions that
come with the optional BrewBuilt Pressure Fermentation Kit.
Do not pressure ferment without using the optional Pressure
Fermentation Kit.
If you wish to ferment under pressure, or capture
Pressure Fermentation Hardware Kit. The optional hardware kit comes with a commercial-grade pressure relief that connects
to the 1.5" TC port on the lid. It also comes with an adjustable spunding valve. The spunding valve allows you to set a safe
pressure to ferment. With the Pressure Fermentation Kit installed, there are three safety relief valves: the standard pressure
relief valve welded into the lid, the commercial 1.5" TC relief valve, and the PRV on the Spunding Valve. The Fermentation kit
includes a no-foam krausen reducer, CellarScience
Using Your CoolStix
Your X1+ comes with an included CoolStix™ and Neoprene jacket. A CoolStix
a cold liquid source such as our BrewBuilt Max 2 or Max 4 Glycol Chiller. Your CoolStix
includes quick disconnects that stay sealed when disconnected to help eliminate messy
leaks. NOTE that CoolStix
™
will not lower your beer to cold crash temperatures (below 40°F) in all situations.
To connect your CoolStix
™
clamps. Insert the temperature probe from your Max 2 or Max 4 into the X1 Thermowell
and follow the directions that come with the unit to set the temperature you wish to keep
your X1 conical at.
The 7-gallon and 14-gallon models use a single rod CoolStix
Reactor Rod™ with four cooling rods. The larger CoolStix
remove the Pressure Pack top to insert the Reactor Rod
the Reactor Rod with the Pressure Pack to sample and transfer under pressure.
™
7 & 14 GALLON
WITH COOLSTIX
™
CO
Foam-Axe to reduce the chance that krausen could enter any of the PRVs.
®
™
are designed to help regulate fermentation temperatures but
to a Max 2 or Max 4 glycol system use ⅜" ID tubing and hose
27 GALLON WITH COOLSTIX
REACTOR ROD
PAGE 8 BREWBUILT.COM
at the end of fermentation, you must use the optional BrewBuilt
2
™ mates with
while the 27-gallon and 42-gallon models use the CoolStix
™
Reactor Rod is made using a 4" TC fitting, so you will need to
™ ™
. After fermentation and cold aging are complete, you can replace
™
™
™
INLET
OUTLET
42 GALLON WITH COOLSTIX
REACTOR ROD
™
™
™