Operating Instructions - Genie DPL Super Series Operator's Manual

Table of Contents

Advertisement

Operator's Manual

Operating Instructions

Do Not Operate Unless:
You learn and practice the principles of safe
machine operation contained in this operator's
manual.
1 Avoid hazardous situations.
2 Always perform a pre-operation
inspection.
3 Always perform function tests prior to use.
4 Inspect the workplace.
5 Only use the machine as it was
intended.
Fundamentals
Using the machine for anything other than lifting
personnel and material to an aerial work site is
unsafe.
If more than one operator is expected to use a
machine at different times in the same work shift,
each operator is expected to follow all safety rules
and instructions in the operator's manual. That
means every new operator should perform a pre-
operation inspection, function tests and a
workplace inspection before using the machine.
18
Setup
1 Position the machine directly below the desired
work area.
2 Connect to an appropriate power source:
DC models: Connect the battery pack.
AC models: Connect to a grounded 15A AC
power supply. Use a 12 gauge / 3.3 mm² 3-wire
grounded extension cord no longer than
50 feet / 13 m.
Air models: Connect the air line.
3 Insert the key and turn to the on position OR
turn to platform control.
4 Pull out the red Emergency Stop button at the
ground controls. Be sure the power light is on or
the air pressure gauge reads 80-110 psi /
5.5-7.8 bar.
5 Install the outriggers and adjust the leveling
jacks to level the machine. Check the bubble
level to be sure the machine is level.
6 Check the interlock display. Be sure that all four
interlock display lights are on.
7 Pull down on the
platform guard rail
locking handle and
rotate the platform side
guard rail to the upright
position. Be sure the
side guard rail locks in
place. Repeat for the
other side.
8 Pull the ladder lock pins and rotate the ladder
down. Be sure the ladder locks in place.
9 Climb the ladder to enter the platform. Close and
latch the platform entry gate and the platform
end guard rail.
Genie DPL Super Series
First Edition • Fifth Printing
Part No. 38132

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dpl-25sDpl-30sDpl-35s

Table of Contents