External Communications; Compatible Software; Optional Battery Modules - Eaton SC200 Installation And Operation Manual

External communications

Refer to the system controller handbook for information on these communications options.
Communications options
Communication with DCTools via USB
Communication with DCTools or PowerManagerII via RS232
Communication with DCTools or PowerManagerII via
an external PSTN or GSM modem (dial-in and dial-out on alarm)
Communication with DCTools or PowerManagerII via Ethernet
Communication with any web browser software via an IP network
Communication with a Network Management System (NMS)
using SNMP
Alarm and status messages to GSM Short Messaging Service (SMS)
text capable cell phones
Communication with an alarm management system using
voltage-free relay contacts (on an IOBGP I/O board)

Compatible Software

The following software is compatible with the SC200 or SC100 system controller:
DCTools Configuration Software. Latest version is available free from
•
www.powerware.com/downloads.
PowerManagerII Remote Control and Monitoring Software. Contact your Eaton dc
•
product supplier for further information (see Worldwide Support on page 73).

Optional Battery Modules

Front View
19-inch rack mount battery module with 48V, 18Ah
battery
Socket for connection to next battery module
Copyright © 2008 Eaton Corporation. All Rights Reserved.
IPN 997-00012-56C
Connection cable to EPS2/EPS5 or previous
battery module
September 2008
General Description
SC200 SC100
-
-
-
-
Rear View
7