Before Charging The Battery; Maintenance - Panasonic EYFLA4A Operating Instructions Manual

• If the battery pack is not connected firm-
ly when the switch is switched on, the over-
heat warning lamp and the battery low
warning lamp will flash to indicate that safe
operation is not possible, and the main unit
EN
will not rotate normally. Connect the battery
pack into the unit of the tool until the red or
yellow label disappears.
[Battery Charger]
Charging
Read the operating manual for Panasonic
bat t ery charger for the battery pack before
charging.

Before charging the battery

Charge the battery at a temperature of 5°C
(41°F) to 40°C (104°F).
The battery pack cannot be charged at a tem-
perature of less than 5°C (41°F). If the tem-
perature of the battery pack is less than 5°C
(41°F), first remove the battery pack from
the charger and allow it to sit for an hour in a
location where the temperature is 5°C (41°F)
or warmer. Then charge the battery pack
again.
V.

MAINTENANCE

Use only a dry, soft cloth for wiping the
unit. Do not use a damp cloth, thinner,
benzine, or other volatile solvents for
cleaning.
VI
. ACCESSORIES
Charger
• EY0L82
Battery pack for EYFLA
• EYFB30
• EYFB32
Battery pack for EYFMA
• EYFB41
• EYFB42
Remote control
• EYFA31
Assembly Qualifier
• EYFR02
Protector for tool EYFLA4 / EYFLA5
• EYFA01-A (Blue)
• EYFA01-Y (Yellow)
• EYFA01-H (Gray)
• EYFA01-G (Green)
Protector for tool EYFLA7 / EYFLA8
• EYFA13-A (Blue)
• EYFA13-Y (Yellow)
• EYFA13-H (Gray)
• EYFA13-G (Green)
• EYFA13-D (Orange)
Protector for battery EYFB30
• EYFA02-H
Protector for battery EYFB32
• EYFA03-H
Protector for battery EYFB41
• EYFA06-H
Protector for battery EYFB42
• EYFA04-H
Retainer ring for tool EYFLA7 / EYFLA8
• WEYME1CK077
Retainer ring for tool EYFLA9 / EYFMA2
• WEY7552K0187
Tool hanger
• EYFA40
CAUTION:
• Tool hanger is for balancer use only.
Excessive force or impact might break it
and the main unit might fall off.
- 54 -
/ EYFLA6 / EYFMA1
/EYFLA9 / EYFMA2