Before Charging The Battery; Maintenance - Panasonic EYFPA1C Series Operating Instructions Manual

[Battery Pack]
For Appropriate Use of Bat­
tery Pack
EN EN
[Fig.20]
• The rechargeable batteries have a limited
life.
• For optimum battery life, store the Li-ion bat-
tery pack following use without charging it.
• When operating the battery pack, make sure
the work place is well ventilated.
For safe use
• The battery pack is designed to be installed
by proceeding two steps for safety. Make
sure the battery pack is installed properly to
the main unit before use.
• If the battery pack is not connected firm-
ly when the switch is switched on, the over-
heat warning lamp and the battery low warn-
ing lamp will flash to indicate that safe oper-
ation is not possible, and the main unit will
not rotate normally. Connect the battery
pack into the unit of the tool until the red or
yellow label disappears.
[Battery Charger]
Charging
Read the operating manual for Panasonic bat-
tery charger for the battery pack before charg-
ing.

Before charging the battery

Charge the battery at a temperature of °C
(1°F) to 0°C (10°F).
The battery pack cannot be charged at a
temperature of less than °C (1°F). If the
temperature of the battery pack is less than
°C (1°F), first remove the battery pack from
the charger and allow it to sit for an hour in a
location where the temperature is °C (1°F)
or warmer. Then charge the battery pack
again.
V.

MAINTENANCE

• Use only a dry, soft cloth for wiping the unit.
Do not use a damp cloth, thinner, benzine,
or other volatile solvents for cleaning.
• Regular greasing is recommended.
Contact your nearest dealer or service cen-
ter.
VI
. ACCESSORIES
Charger
EY0L8
Battery pack for EYFPA1
EYFB60
Battery pack for EYFNA1
EYFB0
Remote control
EYFA1
Protector for tool EYFPA1
• EYFA07-A (Blue)
• EYFA07-Y (Yellow)
• EYFA07-H (Gray)
• EYFA07-G (Green)
Protector for tool EYFNA1
• EYFA09-A (Blue)
• EYFA09-Y (Yellow)
• EYFA09-H (Gray)
• EYFA09-G (Green)
Protector for battery EYFB60
EYFA08-H
Protector for battery EYFB0
EYFA10-H
Tool hanger
EYFA1
CAUTION:
• Tool hanger is for balancer use only.
Excessive force or impact might break it
and the main unit might fall off.
• Use only applicable battery pack;
EYFB60 for EYFPA1
EYFB0 for EYFNA1
- 0 -