Buzzer Setting - Panasonic EYFLA4A Operating Instructions Manual

NOTE:
• When the remaining time prior to the
tightening time is less than 1 hour, the
display will alternate between the "set
value" and "-1".
If the current tightening time remains
unchanged and the inspection duration
is extended, the new set value must be
greater than the current one.
When it reaches the set time, the
display alternates between the set
value and 0.

Buzzer setting

(EYFLA7, EYFLA8, EYFLA9,
EYFMA2)
You can select from three buzzer modes.
1. Set the tool to setting configuration
mode. (See page 46.)
2. Press the A button twice.
The current setting value will be displayed.
3. Press the and
desired value.
Display
b0
b1 Buzzer accompanying green indicator
b2 Buzzer accompanying red indicator
4. Press the OK button to accept the new
setting.
NOTE:
The tool ships with the buzzer mode set to
b0 by default.
LED light setting
(EYFLA7, EYFLA8, EYFLA9,
EYFMA2)
You can select from two LED light modes.
1. Set the tool to setting configuration
mode. (See page 46.)
2. Press the B button once.
The current setting value will be displayed.
3. Press the and
desired value.
Display
d1 Linked to LED light button
d2 Linked to trigger switch operation
4. Press the OK button to accept the new
setting.
buttons to set the
Function
No buzzer
buttons to set the
Function
NOTE:
The tool ships with the LED light mode set
to d1 by default.
Speed control function
(EYFLA7, EYFLA8, EYFLA9,
EYFMA2)
The speed (RPM) can be changed with the
amount of depression of the trigger.
1. Set the tool to setting configuration
mode. (See page 46.)
2. Press the B button three times.
The setting value will be displayed.
3. Press the
desired value.
Operation
P0
P1
4. Press the OK button to accept the new
setting.
Setting the undetect time
(EYFLA7, EYFLA8, EYFLA9,
EYFMA2)
To set the time to undetect the function of
"snug point detection level" from the start
tightening, do as follows.
1. Set the tool to the configuration mode.
(See page 46.)
2. Press button A three times.
• The current set value is displayed, and the
main unit panel starts flashing.
Display: J0 flashing.
Battery capacity indicator: The upper and
lower bars flash.
[Fig.31]
3. Press and
change the time.
Operation
4. Press the OK button to accept the new
setting.
- 49 -
and buttons to set the
Function
Speed control ON
Speed control OFF
buttons as required to
Display Seconds
30 3
1 0.1
J0 OFF
EN