Introduction Of Control Pane - Gree GJC07AJ-D6DRNC2A Service Manual

6. Function and Control
Service Manual

6.2 Introduction of Control Pane

After putting through the power, air conditioner will give out a sound and indicators on control panel will be on. After that, you operate the
air conditioner through remote controller or control panel.
Note:If wireless remote controller is lost, open the surface panel and operate manually.
5
6
7
1. POWER BUTTON
Operation starts when pressing this button, and stops when pressing this button again.
2.SWING BUTTON
Activate the automatic air swing function.
3.FAN SPEED BUTTON
Select the fan speed LOW, MID, HIGH and AUTO in sequence.
4.TEMP/TIMER BUTTON
Press the ▲ keypad to increase the set (operating) temperature of the unit.and Press the ▼ keypad to decrease the set (operating)
temperature of the unit. The temperature seting range is from 16~30℃ .
Timer can be set by pressing ▲/▼ button. Timer can be set in 0.5hour increments between 1 and 10 hours, or in 1hour increments for 10
hours or above after each push on ▲ or ▼ button.
5.SIGNAL RECEIVER
6.MODE BUTTON
Select the operation mode, COOL,DRY,FAN (for reverse cycle model).
7.FILTER BUTTON
This feature is a reminder to clean the Air Filter (See Care and Cleaning) for more efficient operation and cooling. The LED (light) will
illuminate after 250 hours of operation. To reset after cleaning the filter, press the "Check Filter" button and the light will go off.
Technical Information
9