Shining 3D AccuFab-D1s Quick Start Manual
  1. Manuals
  2. Brands
  3. Shining 3D Manuals
  4. 3D Printers
  5. AccuFab-D1s
  6. Quick start manual

Shining 3D AccuFab-D1s Quick Start Manual

Hide thumbs Also See for AccuFab-D1s:
1
2
3
4
5
6
7
Table of Contents

Advertisement

Quick Links

Download this manual
AccuFab-D1s
3D Printer
Quick Start Guide

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the AccuFab-D1s and is the answer not in the manual?

Questions and answers

Related Manuals for Shining 3D AccuFab-D1s

Summary of Contents for Shining 3D AccuFab-D1s

  • Page 1 AccuFab-D1s 3D Printer Quick Start Guide...

  • Page 2: Installation Procedure

    Installation Procedure STEP 1 Unpacking Open the cover, take out accessory box,resin tank x 2, power adaptor and power 2 ） 1 ） Remove steel clasps on the wooden case cable from fixing foam. to open it. Cut the straps and open the Take out resin tanks and remove the protective films.

  • Page 3: Install The Printer

    STEP 3 Install the Printer The build platform bracket will move up automatically after booting the printer. It is time to install the resin tank and the build platform. Install the resin tank Remove the protective film on the protection glass. Inset the resin tank into the card slot and push it to the end in the direction indicated in the figure.

  • Page 4: Product Preview

    Product Preview Handle Build Platform Bracket Build Platform Chamber Door Z axis Resin Tank Network port Power port Protection Glass Touch Screen Power Button B-type USB port Power button (back) USB Port （front） Part List ① Build Platform 2 x Resin Tank Power Adaptor Power Cable ②...

  • Page 5: First Print

    First Print STEP 1 Installation of Software Insert the flash drive came with printer into the PC, Copy the installation file to the PC. “AccuWare_3.1.X.XXX_release_install.exe” And run it. Install the software following the installation wizard. Click Finish to finish and run the software. Note: DO NOT run the installation file from the flash drive.

  • Page 6: Data Preparation

    Confirm printing (1.Resin 2.ResinTank 3.Light Path) ,and then click Close the chamber door and tap next to start printing. “Next”. Note: If you find software expired,please active the license according to the <AccuFab-D1s User Manual>. STEP 7 Post-processing After finishing the print, take down the build platform and remove the model. Clean, dry, and cure the model. For more details about postprocessing,...
  • Page 7 Document Download Center: upport Center: Aftersales service: Technical resource:...

Table of Contents