Hamron 008377 Operating Instructions Manual page 22

EN
8. Mains power (AC)
9. Switched off
10. Battery power (DC)
11. Mains connection
FIG. 1
1. Plug for 230 VAC
2. Air hose
3. Venting valve
4. Extension nozzle
5. Needle nozzle
6. Plug for 12 VDC
FIG. 2
USE
AUTOMATIC PRESSURE MONITOR
First set the voltage switch to AC for mains
power, or to DC for battery power in the
vehicle.
1. Press the (+) or (–) button for about 5
seconds, until the display starts flashing.
Set the required pressure with the (+)
or (–) button and then wait for 3 to 4
seconds. The display stops flashing and
shows the set pressure to which the tyre
will be filled.
2. Press the power switch to start the
compressor. When the set pressure is
reached the compressor switches off and
OFF is shown in the display.
INFLATING TYRES
1. Screw the hose connection on the tyre
valve.
FIG. 3
2. Put the plug in the 12 V outlet in the
vehicle.
FIG. 4
22
3. Set the required pressure (see section
"Automatic pressure monitor").
FIG. 5
4. Activate the automatic pressure monitor
and press the power switch. The
compressor switches off automatically
when the set pressure is reached. Switch
off the compressor switch afterwards.
ACCESSORY NOZZLES
1. Screw on the required accessory nozzle
(conical nozzle or needle nozzle) on the
air hose connection. Tighten until the
connection is airtight.
FIG. 6
2. Put the accessory nozzle in the air
connection in the object to be filled.
NOTE:
Extension nozzle, conical standard nozzle and
needle nozzle supplied.
VOLTAGE SWITCH
The voltage switch is on the back of the
product. The switch must be in the correct
position to use the power supply, "AC" for
mains voltage and "DC" for battery voltage.
FIG. 7
Mains power (230 V)
Always pull out the full length of the power
cord before use. Plug the plug in a power point
and press the switch button marked AC to start
the product. To switch off the product, press the
switch button marked DC until the button clicks
back 1 step to position 0.