Operation; Before First Use - Stadler Form QuickUp One Operating Instructions Manual

6. Main on/off power switch
7. Housing
8. Water tank
9. Water level scale

OPERATION

BEFORE FIRST USE

• Remove the thermopot from the box and remove all the packing materials
from it.
• Rinse the thermopot before first use. To do this, fill the tank with water
to the maximum level mark, then boil and drain it. Repeat this procedure
2-3 times to remove dirt and residue from the factory and transportation.
• Wipe the external surfaces of the device with a wet napkin, then a dry
one.
USE
1. Lift the lid, then grab the water tank by the handle and remove it.
2. Fill the tank with cold water, but not above the maximum level mark.
Make sure the water level is always between the maximum and mini-
mum level marks. You can also pour water into the tank without remo-
ving it from the base. Pour the water carefully to prevent spillage on the
housing or control panel.
3. Set the tank in place and close the lid.
4. Plug in the thermopot and switch it on using the main switch. The blue
temperature control light will turn on. This means that the thermopot
is in standby mode. Water heating is produced within 10 minutes after
turning on.
NOTE
If after Thermopot turning on within 10 minutes any button is not pressed
on control panel, the control panel lock function will automatically acti-
vated.
Control panel lock button (protection against children)
This button is intended for locking all buttons at the control panel to pro-
tect against unauthorized access (protection against children).
Press this button to lock the control panel. Thus all button lights at the con-
trol panel will go out and the control panel will be locked.
To cancel locking, press this button again and keep pressed for 2 seconds.
Herewith, button lighting will blink, and then blue lighting of the tempe-
rature regulator will go on — it means that Thermopot was switched in
standby mode.
Push button of water delivery without heating (200ml)
This button is intended for delivering water (200 ml) with indoor tempe-
rature.
Press this button to pour in a cup 200 ml of water with indoor temperature,
button illumination thus will go on. After water delivery button lighting will
be disconnected and Thermopot will automatically be switched in standby
mode.
To stop water delivery just press this button repeatedly, thus water delivery
will stop, button lighting will be switched off, and Thermopot will be swit-
ched in standby mode.
NOTE
If the quantity of water in the tank isn't enough the lights of all buttons at
the control panel will blink, and water delivery will be locked.
Avoid accidental Thermopot switching on without water or at filling tank
below a minimum level mark.
Program cancel button
This button is used to cancel the selected function.
Click this button to cancel the water dispensing function for a small or large
cup.
NOTE
This button will blink if there is not enough water in the tank. To disable this
signal, press any button on the control panel.
Avoid accidentally switching on the thermopot if the water tank is empty or
the water is below the minimum level mark.
Temperature knob
The temperature knob is used to select the desired water temperature.
When the thermopot is in standby mode, turn the knob to the desired water
temperature: 60°C/70°C/80°C/85°C/90°C/95°C/100°C.
Push button for water delivery to a small cap (100ml)
This button is intended for heating and delivering 100 ml of water.
Choose temperature of water heating for a small cup by means of the regu-
lator. Then press this button, button lighting thus will go on. The tempera-
ture regulator lighting will change intensity of a luminescence — it means
that water heating is carried out.