Table of Contents
Advertisement
en Installation instructions
Ensure that the wall socket is located in the hatched
area
or outside of the installation space.
Secure any unsecured units to the wall using a stand-
ard bracket
.
21.4 Installation below a worktop
Observe the installation dimensions and the safety
clearances when installing below a worktop.
To ventilate the appliance, the intermediate floor must
have a ventilation cut-out.
The worktop must be secured to the fitted unit.
21.5 Installing below a hob
If the appliance is installed below a hob, the following
minimum dimensions must be adhered to (including
substructure, if applicable).
The required minimum worktop thickness
on the required minimum clearance
44
is based
.
Hob type
raised in
mm
Induction hob
48
Full-surface in-
58
duction hob
Observe the installation instructions for the hob.
Note: Not suitable for installing under a gas hob or
electric hob.
21.6 Installation in a tall unit
Observe the installation dimensions and the safety
clearances in a tall unit.
To ventilate the appliance, the intermediate floor must
have a ventilation cut-out.
If the tall unit has another back panel in addition to the
element back panels, this must be removed.
Do not fit the appliance too high up; it must be pos-
sible for accessories to be removed easily.
21.7 Combination with a warming drawer
First fit the warming drawer. Follow the installation in-
structions for the warming drawer.
Slide the appliance, on the warming drawer, into the fit-
ted cabinet. When sliding in the appliance, do not dam-
age the warming drawer's panel.
21.8 Corner installation
Observe the installation dimensions and the safety
clearances when installing in a corner.
flush in
in
mm
mm
49
5
59
5
Advertisement
Table of Contents
