Connecting Your Triplehead2Go Digital Se Product; Before You Begin - Matrox DualHead2Go User Manual

Connecting your TripleHead2Go Digital
SE product
This section describes how to connect up to three digital (DVI-D) monitors to your Matrox product.
To connect three monitors,
To connect two monitors,
WARNING:
DisplayPort connector on your DisplayPort
monitor cable or on your Matrox product,
carefully remove the DisplayPort cable by
pressing the latch on the top of the DisplayPort
connector while removing the connector.
Note:
Matrox online store (shopmatrox.com).

Before you begin

To avoid possible problems that could damage your monitors or prevent you from using your Matrox
product, read the following guidelines before connecting your Matrox product.
Whenever you change your connection setup, make sure you're using the correct
connectors and that all connectors are properly fastened.
Don't change monitor connections while your computer is turned on. While your
computer is turned on, it may be using monitor settings that are specific to the current
monitor connections. Some devices may be permanently damaged if incorrect settings
are used.
To get the most out of your Matrox product, we recommend you use two identical
monitors (that is, monitors that support the same settings such as display resolution and
refresh rate). For information on the settings your monitor supports, see your monitor
documentation.
see "Connecting two monitors", page
To avoid damaging the
To purchase any Matrox cables or adapters not included with your product, see the
see "Connecting three monitors", page
Matrox GXM – User Guide (Mac version) 33
34.
37.