Connecting Your Triplehead2Go Digital Edition Product; Before You Begin - Matrox DualHead2Go User Manual

Connecting your TripleHead2Go Digital
Edition product
This section describes how to connect up to three (3) digital (DVI-I) or analog monitors to your
Matrox product.
To connect three (3) monitors,
To connect two (2) monitors,
Note:
Matrox online store (shopmatrox.com). To purchase any optional Apple cables or
adapters, see your Apple retailer.

Before you begin

To avoid possible problems that could damage your monitors or prevent you from using your Matrox
product, read the following guidelines before connecting your Matrox product.
Whenever you change your connection setup, make sure you're using the correct
connectors and that all connectors are properly fastened.
Don't change monitor connections while your computer is turned on. While your
computer is turned on, it may be using monitor settings that are specific to the current
monitor connections. Some devices may be permanently damaged if incorrect settings
are used.
To get the most out of your Matrox product, we recommend you use three (3) identical
monitors (that is, monitors that support the same settings such as display resolution and
refresh rate). For information on the settings your monitor supports, see your monitor
documentation.
While using the DVI input connector on your Matrox product, the highest display
resolutions are available only with graphics hardware that supports dual-link DVI. For
information on the capabilities of your graphics hardware, see its documentation.
To purchase any Matrox cables or adapters not included with your product, see the
see "Connecting three monitors", page
see "Connecting two monitors", page
Matrox GXM – User Guide (Mac version) 19
20.
23.