Accessories; Environment - Festool KAPEX KS120 REB Original Instructions Manual

English
► Check the angle adjustment by making a
sample cut.
9.3 Correcting vertical mitre angles
Should the actual value no longer correspond to
the angle you set, this can be corrected:
► Lock the saw unit in the 0° position.
► Loosen the two screws [23.1].
► Swivel the saw unit until it matches the ac­
tual 0° value. You can check this against an
angle between the saw table and the saw
blade.
► Retighten the two screws [23.1].
► Check the angle adjustment by making a
sample cut.
Should the indicator [22.2] no longer point to
the set value, you can adjust it after loosening
the screw [22.1].
9.4 Replacing the table top insert
Do not work with a worn-out table top in­
sert [20.1]; replace it with a new one instead.
► Unscrew the six screws [20.2] to replace
the table top insert.
9.5 Cleaning/replacing the window for the
laser (KS 120 REB only)
The window [21.2] which protects the laser can
become dirty during operation. You can remove
the window to clean or replace it.
► Loosen the screw [21.5] by approx. two ro­
tations.
► At the same time, push the window in direc­
tions [21.3] and [21.4].
► Remove the window.
► Clean the window or replace it with a new
one.
경기도 의왕시 맑은내길 67, 501-2호
(오전동, 에이엘티지식산업센터)
(우) 16071
전화: 02-6022-6740
팩스: 02-6022-6799
http://www.festool.co.kr
38
► Insert the cleaned/new window. The two
pins [21.1] of the window must engage in
the recesses of the upper guard as show in
figure 21.
► Tighten the screw [21.5].

10 Accessories

Use only original Festool accessories.
Refer to the Festool catalogue for the order
numbers of accessories and tools or find them
online at www.festool.co.uk.
In addition to the accessories described,
Festool also provides a comprehensive range of
system accessories that allow you to use your
saw more effectively and in diverse applica­
tions, e.g.:
• Saw blades for different materials.
• KA-KS 120 table extension
• UG-KAPEX KS 120 underframe
• AB KS 120 crown stop

11 Environment

Do not dispose of the device in the
household waste! Recycle devices, ac­
cessories and packaging. Observe appli­
cable national regulations.
EU only: In accordance with the European Di­
rective on waste electrical and electronic
equipment and implementation in national law,
used power tools must be collected separately
and handed in for environmentally friendly re­
cycling.
Information on REACH: www.festool.com/reach
ALT Center A 5F, Malgeunnae-gil 67
Uiwang-si, Gyeonggi-do
16071
phone: 02-6022-6740
fax: 02-6022-6799
http://www.festool.co.kr