Installation - BMW Wallbox Instructions For Use Manual

3.6 Mains isolator
The BMW Wallbox does not have a main switch. The RCCB and circuit breaker on the building
installation are used as the mains isolator.

4 Installation

4.1 Installation requirements
Comply with the local installation regulations.
Acclimatisation: If there is a temperature difference of more than 15 °C between transport and
the selected installation site, the BMW Wallbox must be allowed to acclimatise unopened for at
least two hours. Opening the BMW Wallbox immediately may result in condensation forming in its
interior and causing damage when the device is switched on. In certain circumstances, damage
caused by condensation formation may also not appear until after the installation. Ideally, the BMW
Wallbox should be stored for several hours at the installation site before installation. If this is not
possible, the BMW Wallbox should not be stored in low temperatures (< 5 °C) overnight outdoors
or in a vehicle.
4.2 List of tools
Measuring tool and pen
Drill
Torx T30 screwdriver
Torx T20 security screwdriver
Cross-head screwdriver No. 2
Crimping tools
4.3 Recommended installation site
When selecting the installation site, consider access from the charging socket to the vehicle and the
direction in which the vehicle is normally parked.
12