Page 3
Unpacking In case of damage or lack of any part when unpacking then please contact our local distributor or contact us by e-mail: export@rocker.com.tw with model and series number for immediate assistance. Vacuum Pump...
Page 4
Assembly & Disassembly diagram Installation Ensure to check voltage specified on the nameplate at the bottom of the pump. Make sure if it matches the line voltage on your location. ℃. Install the pump in a clean, dust-less and ventilated area where the ambient under 40 Connect (4) air inlet with a high-pressure hose as short as possible and check if all the connections are tightly sealed and without air leakage.
Page 5
Warning The pump is NOT in “chemically-resistant” design. Do not use the pump with organic or corrosive gases. Never use the pump with any flammable gas or toxic material. When used with liquid filtration, please always prevent liquid from being drawn into the pump to cause severe damage to the pump.
Page 6
Operation Turn on (1) the power switch and run the pump for 1 min. then check through (3) oil level window if the current oil level is between Max. and Min. line. If under Min. line then make sure to add Tanker SC lubricant (187100-10). ...
Page 7
Basic Troubleshooting Failure to start: Check if the input voltage is within + or (-) 10%. The improper input voltage will cause a failure to start. Oil leakage: Ensure that the leaking oil is not the residues of oil. ...
Need help?
Do you have a question about the Tanker 130 and is the answer not in the manual?
Questions and answers