Adding Or Removing Roof Panel - Tripp Lite SmartRack SRTH6UB Owner's Manual

Configuration

Adding or Removing Roof Panel

WARNING: Do not attempt to use the roof panel for weight-bearing purposes other than those explicitly described
and approved by Tripp Lite. Do not attempt to add or remove the roof panel without assistance.
Removing Roof Panel
1
Pull the 2 pins near the rear of the roof panel. While holding the pins,
push the roof panel upward.
2
Remove the roof panel tabs
in the enclosure frame.
B
3
Disconnect the ground wire located on the side panel.
4
Lift the roof panel from the enclosure.
To Reinstall Roof Panel, Reverse Steps 1-4
from the roof panel attachment slots
A
1
2
3
4
9
1
2
A
B