Lan - Telrad CPE12350 User Manual

Connection Mode:

NAT:

Default Enable
MGMT and Date Interface:

4.2.3

LAN

On this page, include "LAN Reset", "Device IP" and "DHCP"
LAN Reset:

Restore of LAN default setting.
Duplex:

Auot/Full/Half
Max Bit Rate:

10Mbps/100Mbps/1000Mbps
Local IP Address：Enter the IP address of your router (factory default:

192.168.0.1).
 Subnet Mask：An address code that determines the size of the network.
Normally use 255.255.255.0 as the subnet mask.
 DHCP：Defaul Enable
 DHCP Address Allocation: Specify an IP address for the DHCP server to start
and end with when assigning IP address.
 DHCP lease time: The Lease Time is the amount of time a network user will
be allowed connection to the router with their current dynamic IP address.
Enter the amount of time in minutes and the user will be "leased" this
dynamic IP address. After the time is up, the user will be assigned a new
dynamic IP address automatically.
 Static IP - IP/MAC binding function, the system will assign a fixed IP address
to the MAC according to the rules.
CPE User Manual V0.1
Telrad CPE12350 User Manual
Figure 4-2-2-1 Internet
Route/NAT, L2 Bridge(GRE), L3 Bridge
Combine/ Separate
Figure 4-2-3-1 LAN
9