Advertisement
Quick Links
Advertisement
Related Manuals for Telrad 2D1VWIFIAP
Summary of Contents for Telrad 2D1VWIFIAP
- Page 1 Indoor WiFi AP Quick installation Guide...
- Page 2 Copyright This DOCUMENT is copyrighted with all rights reserved. No part of this publication may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any language in any form by any means without the written permission of Telnet. Notice Telnet reserves the right to change specifications without prior notice.
-
Page 3: Table Of Contents
Contents Copyright Notice Contents ..................1 1. About this Guide ..............2 2. What’s in the box? ..............2 3. Connectors & LED Indicators ........... 3 4. Connect IDU to ODU ............... 5 5. Easy Setup ................6 6. Wi-Fi Setting ................7 7. -
Page 4: About This Guide
1. About this Guide This document provides information and procedures on installation/configuration of LTE Indoor CPE. You could utilize the theoretical information in this guide to setup your device. This Quick Installation Guide covers the basic installation of the Indoor Gateway. 2. -
Page 5: Connectors & Led Indicators
3. Connectors & LED Indicators IDU Rear Panel IDU Front Panel... - Page 6 IDU LED Indicators: Type Color Action Description Green Solid ON Power on Power Power off Green Solid ON System is booting System System is disabled Display signal strength 1 LED: 0<=CINR<8 Green Solid ON LTE Signal Strength 2 LED: 8<=CINR<24 3 LED: 24<=CINR No signal Green...
-
Page 7: Connect Idu To Odu
4. Connect IDU to ODU CAUTION DO NOT CONNECT A COMPUTER OR A SWITCH DIRECTLY TO THE IDU’S POE PORT DUE TO THE HIGH POE POWER (56V). Connect the IDU, ODU & IDU Hardware Connections 1. Connect the CAT 5 Ethernet cable which is already connected to the ODU to the IDU’s RJ-45(WAN) POE port.(Suggest to use Cat5E shielded Patch Cable, and must not exceed 100m). -
Page 8: Easy Setup
5. Easy Setup Physical connection as following (Refer to Installing Device Instruction). ․Make sure there is a SIM in ODU(SIM CARD SLOT). ․Connect IDU(WAN) and ODU(RJ45 & POE POWER SLOT) via Ethernet cable. ․Use power adapter to connect IDU(Power). ․Connect IDU(ETHERNET PORTS) and PC via Ethernet cable. Please follow the steps below to configure your device through the web interface: Step1: Open the Web browser (Internet Explorer) and enter the default IP address of the ODU CPE, which is :... -
Page 9: Wi-Fi Setting
6. Wi-Fi Setting Step1: Select WIFI from main menu. Then screen will display the default setting of SSID, radio channel, working mode, and SSID broadcast. Step2: You could specify a radio channel, working mode, bandwidth in Settings page. -
Page 10: Make Phone Call
7. Make Phone Call The VoIP settings should be provided by your VoIP service provider. VoIP doesn’t support “flash + number” feature. Using a telephone connected to the PHONE port on IDU device, and making a call to another phone (either an Internet phone, or a regular PSTN number). If you are able to call the other number, your VoIP setup is working properly. - Page 11 Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
- Page 12 Industry Canada statement: This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to the following two conditions: (1) This device may not cause interference; and (2) This device must accept any interference, including interference that may cause undesired operation of the device.