Introduction - Konica Minolta AeroDR SYSTEM Operation Manual

Introduction

The digital radiography AeroDR SYSTEM, AeroDR SYSTEM 2 and SKR 3000 (hereinafter, both are referred to as
this device) perform X-ray imaging of the human body using an X-ray planar detector that outputs a digital signal,
which is then input into an image processing device, and the acquired image is then transmitted to a filing system,
printer, and image display device as diagnostic image data.
• Diagnostic X-ray image data of this device does not provide mammographic images.
• This device is also used for carrying out exposures on children.
The CS-7 or ImagePilot (hereafter referred to as the image processing controller), which controls the receiving, pro-
cessing, and output of image data, is required for operation. For the operation of the image processing controller,
refer to the "Operation Manual" of the image processing controller. Also, regarding the connectable devices, contact
Konica Minolta technical representative.
This operation manual provides instructions on the basic functions for operation of this device. Those operating this
device for the first time should read this manual beforehand.
Also, store this manual close to this device after reading it through, so it can be used as a guide to allow optimum
operating conditions.
IMPORTANT
• This operation manual (English version) is effective only outside Japan.
• This Operation Manual is common to three types of the digital radiography AeroDR SYSTEM, digital radiography AeroDR SYS-
TEM 2 and digital radiography SKR 3000.
• If the pages of the operation manual are smudged and illegible, replace it with a new one. (a fee is required.)
• The illustrations in this manual use the AeroDR 3 1417HD and AeroDR Battery Charger2 as the example.
6