Precautions For Installing, Moving; And Storing - Konica Minolta AeroDR SYSTEM Operation Manual

1�3�5 Precautions for installing,
moving, and storing
WARNING
• Take note of the following when moving this device not
including the DR Detector:
— Do not subject to shocks or vibration .
— Do not start moving until the power is turned off, and
operation has stopped completely.
— Do not move with the power cable or any other cable
connected
— Do not install the power cable, Ethernet cable and
wired cable so that you do not catch them on your
feet and so on
— Be careful not to drop the DR Detector on any part of
a person's body.
— Install on a horizontal and stable surface.
• When installing the AeroDR Battery Charger or AeroDR
Battery Charger2 on a table top, observe the following:
— Install on a base that can withstand maximum patient
weight because load is inserted when setting the DR
Detector
— The contact area for the AeroDR Battery Charger or
AeroDR Battery Charger2 must be larger than the
area of the AeroDR Battery Charger or AeroDR Bat-
tery Charger2 so that it will not fall down when the
DR Detector is inserted or when people touch it by
accident
— Do not use a base that has a surface made of slip-
pery material such as teflon.
— Connect power cable and wires so that no one will
trip
— Install in a place easy to insert the DR Detector.
— Install so that the vent on the back side of the Aero-
DR Battery Charger is not blocked.
CAUTION
• Because connections of the X-ray device can only be
made by Konica Minolta or its designated contractors,
contact Konica Minolta or its designated contractors.
• For the X-ray devices enabled to connect, contact Koni-
ca Minolta technical representatives.
• Contact Konica Minolta or dealers specified by Konica
Minolta to install or move this device.
• Since it is required to meet the specification provided
by the X-ray device manufacturer to connect with an X-
ray device, contact Konica Minolta or dealers specified
by Konica Minolta.
• Take note of the following when installing or storing this
device.
— Install or store this device within the specified storage
and usage conditions and environment.
— Do not install or store in a location where it may be
adversely affected by atmospheric pressure, tem-
perature, humidity, ventilation, sunlight, dust, salt-air,
or air containing sulfur.
— Do not install or store in a location where it is not sta-
ble, ventilation is insufficient, the difference in light-
dark is great, electromagnetic waves are generated,
or where subject to vibration or shock.
— Do not install or store in a location where chemical
agents are used or stored.
— Do not install this device facing up or upside down.
— Do not install the AeroDR Interface Unit, AeroDR
Interface Unit2 and AeroDR Generator Interface Unit
stacked on each other.
• Connect the AeroDR Interface Unit2, AeroDR Genera-
tor Interface Unit, AeroDR Generator Interface Unit2
and Generator Interface Unit 3 to an X-ray device that
conforms to IEC 60601 or to an equivalent standard.
• Contact Konica Minolta or dealers specified by Konica
Minolta with regard to the information of compatible X-
ray devices.
27
Safety precautions
1
2
3
4
5
6
7
8
9
10
11
12