Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Oben VH-A30
Summary of Contents for Oben VH-A30
- Page 1 VH-A30 Tilt Head for Monopods You’re on steady ground ®...
- Page 2 INTRODUCTION Thank you for choosing Oben The Oben VH-A30 Tilt Head is a sturdy, all-aluminum tilt head designed for monopods. It provides 180° vertical tilt for a camera and lens weighing up to 33 pounds, and its durable construction will stand up to the most demanding indoor and outdoor use.
-
Page 3: Table Of Contents
TABLE OF CONTENTS Overview ____________________________ 4-5 Operation ____________________________6-9 Mounting the Head to a Monopod ____________6 Mounting the Quick-Release Plate ____________6 Mounting the Camera/Lens _________________7 Tilt Lock Knob ___________________________8 Quick-Release Knob ______________________8 Repositioning the Clamp ___________________9 Specifications _________________________10 Warnings ______________________________11... -
Page 4: Overview
OVERVIEW... - Page 5 OVERVIEW Quick-release plate 1/4-20 mounting screw Clamp attachment screw Quick-release knob Quick-release clamp Tilt lock knob 3/8-16 mounting socket Bubble level...
-
Page 6: Operation
OPERATION OPERATION Mounting the Head to a Monopod 1. Screw the head onto your monopod. 2. Once attached, make sure the head’s base is flush against the monopod’s top mount. 3. If your monopod has a set screw, tighten it until secure. Mounting the Quick-Release Plate The plate’s 1/4-20 screw will fit most cameras and lenses. -
Page 7: Mounting The Camera/Lens
OPERATION OPERATION Mounting the Camera/Lens 1. Before mounting the camera or lens to the head, make sure the tilt lock knob is fully tightened. 2. Place the quick-release plate and camera/lens into the clamp. 3. Adjust the plate’s position for optimum balance. -
Page 8: Tilt Lock Knob
OPERATION Tilt Lock Knob 1. Turn the tilt lock knob counterclockwise to unlock the head. 2. Position the angle of the head, and turn the knob clockwise to tighten it. Important: Always use one hand to hold onto your camera while adjusting the head. -
Page 9: Repositioning The Clamp
OPERATION Repositioning the Clamp For convenience, the clamp’s position can be repositioned, so the quick-release knob and the tilt-lock knob are on opposite sides of the head. 1. Remove the quick-release plate. 2. Use the hex key to remove the clamp attachment screw. -
Page 10: Specifications
SPECIFICATIONS Head Type Tilt Base Mount 3/8-16 Camera Mounting Screw 1/4-20 Quick-Release Plate QR-20 Load Capacity 33 lb. (15 kg) Number of Bubble Levels Material Aluminum Vertical Tilt +90° to -90° Dimensions (H × W × D) 3.5 × 3.6 × 2.4 in. (8.9 ×... -
Page 11: Warnings
33 lb (15 kg). • Ensure that all appropriate locks are engaged when necessary. • The VH-A30 head should be used only in temperatures ranging between -4°F and 158°F (-20°C and 70°C). • Do not operate in salt water. Dry the head if it becomes wet. - Page 12 www.obensupports.com...
Need help?
Do you have a question about the VH-A30 and is the answer not in the manual?
Questions and answers