Table of Contents
Advertisement
Introduction
This chapter mainly describes how to install the engine and provides physical and electrical information, cautions and
window properties.
△
Caution：Do not touch the imaging lens during the installation. Do not leave the fingerprints on the lens.
！
△
Caution：Do not touch the LED when handling to prevent damage to the LED lens.
！
General Requirements
ESD
ESD protection has been taken into account when designing the EM3080-W V2 and the engine is shipped in ESD safe
packaging. Always exercise care when handling the engine outside its package. Be sure grounding wrist straps and
properly grounded work areas are used.
Dust and Dirt
The EM3080-W V2 must be sufficiently enclosed to prevent dust particles from gathering on the lens and circuit board.
Dust and other external contaminants will eventually degrade the engine's performance.
Ambient Environment
The following environmental requirements should be met to ensure good performance of the EM3080-W V2.
Table 2-1
Operating Temperature
Storage Temperature
Humidity
9
Chapter 2 Installation
-20℃ to 50℃
-40℃ to 70℃
5% ~95% (non-condensing)
Advertisement
Table of Contents
