Table of Contents
Advertisement
8
KTD-400 Controller Keypad
User Manual
6. Use the menu in Figure 13 to deny or permit
the controller keypad's access to certain
monitors. Press 0 to deny access or 1 to
permit access. After each selection, the next
monitor number will appear. Use the up and
down directional arrows to move between
monitors. When done, press Seq to advance
to the next menu.
7. The menus in Figure 14 let you select which
multiplexers can be enabled from the
keypad. The first display will only come up
if your system has at least one multiplexer.
•
If you don't want to enable any
multiplexers, press Seq to advance to the
VCR access menu (Figure 16 on
page 9).
•
Press 0 to advance to the next
multiplexer, or use the up and down
arrows to move between multiplexers.
•
Press 1 to enable a multiplexer. This will
advance you to the multiplexer select
display. Use the up and down arrows to
scroll through the alphabetical list of
models. After selecting a multiplexer,
press Seq to advance to the next menu.
8. The multiplexer view display (Figure 15)
determines which views will be enabled
when the keypad is in multiplexer operating
mode. (In multiplexer operating mode,
pressing View toggles through the views.)
Some multiplexer models do not have
selectable views and will skip this menu.
Use the down key to scroll through the
list of views available. For each view,
press 1 to accept or 0 to decline. After
you have selected all views, press Seq to
return to the multiplexer enabled menu
display (Figure 14).
Figure 13. Monitor access display
MONITOR 01
0=NO
1=YES
Figure 14. Multiplexer access menus
MPLXR 01
0=NO
1=YES
MPLX 01:
SELECT(
)
Figure 15. Multiplexer view display
VIEW: PIP
0=NO
1=YES
=NXT
ACC=YES
SEQ=NEXT
ACC=NO
SEQ=NEXT
ATV
SEQ=NEXT
YES
SEQ=EX
Advertisement
Table of Contents
