Table of Contents
Advertisement
To attach the device to the vehicle:
1. Wipe the mounting surface on the vehicle to ensure it is free from scratches, dust or dirt.
2. Remove the plastic protection plate from the bottom of the cup.
3. Wipe the base of the suction pad to ensure that it is thoroughly clean.
4. Place the suction pad firmly onto the mounting surface.
5. Repeatedly press the plunger until the red line disappears into the housing
Please note: It is recommended to regularly check that the red line does not re-appear on the
plunger. If it does, repeatedly press the plunger again until it disappears.
To release:
1. Hold the RT-XLAN tight with one hand
2. With the other hand, lift the black tabs on the side of the base to firmly break the seal then
carefully pull the device away from the vehicle.
Note: Care should be exercised when removing the device, there may still be a strong
vacuum seal holding it to the mounting surface.
The plastic protection plate should be retained and replaced on the cup when not in use to protect the
surface from damage.
Although the RT-XLAN is weather resistant, we strongly recommend that the N-Type connector from
the device to the antenna is covered with self-amalgamating tape to help protect it from moisture.
Figure 2. Attaching and removing the pump cup
NOTE: When removing the pump cup from the vehicle, please take extra care to fully break the seal
on the base using the tab before attempting to pull the device away.
A number of mounting options are available, some of which are shown in Figure 3.
Oxford Technical Solutions Ltd
www.oxts.com
Page 7 of 18
Advertisement
Table of Contents
