Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for OXTS RT
Summary of Contents for OXTS RT
- Page 1 Quick Start Guide RT-Range Survey Trolley...
-
Page 2: Legal Notices
Contact details Oxford Technical Solutions Limited Park Farm Business Centre Middleton Stoney Oxfordshire OX25 4AL United Kingdom Tel: +44 (0) 1869 814 253 Fax: +44 (0) 1869 251 764 Web: https://www.oxts.com Email: support@oxts.com Oxford Technical Solutions Ltd www.oxts.com Page 1 of 10... -
Page 3: Warranty
Technical Solutions Limited with respect to the products herein. Environmental protection Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check with your Local Authority or OxTS representative for recycling advice. Oxford Technical Solutions Ltd www.oxts.com... -
Page 4: Table Of Contents
Environmental protection ........................2 Survey trolley ............................4 Components ............................5 Installation ............................... 6 RT3000 v3 installation ......................... 9 Physical orientation: ..........................9 Software configuration: ........................10 Revision history ............................. 10 Oxford Technical Solutions Ltd www.oxts.com Page 3 of 10... -
Page 5: Survey Trolley
Survey trolley The RT-Range Survey Trolley is an accessory which enables you to accurately survey the position of lanes for vehicle-to-lane testing. Figure 1. Survey Trolley Oxford Technical Solutions Ltd www.oxts.com Page 4 of 10... -
Page 6: Components
The Survey Trolley will require a battery. Please note that this is not supplied by OxTS and must be purchased by the customer. The ideal battery is a Yuasa NP24-12, a 12 V, 24 Ah lead acid battery measuring 166 ×... -
Page 7: Installation
Installation The Survey Trolley has been designed to carry the RT, a battery and a laptop computer. The GPS antenna on the Survey Trolley is sufficiently high so that there will be minimal interference from the operator. The position measurements are displaced to the front right wheel so that this wheel can be pushed along the road markings. - Page 8 Figure 4. If a trigger switch is being used, then it should be connected to J5 of the RT. A trigger event can be made by shorting the Event Input pin on J5 of the 14C0038A User Cable to ground. The trigger event can be used to place a point in the line file for the map.
- Page 9 Note: The connection is shown here with the SATEL radio option. The Freewave and other radio options are similar. The RT will need to be configured correctly for use on the Survey Trolley. Table 2 lists the critical configuration parameters that should be used with the Survey Trolley. Other parameters can be left at the default values.
-
Page 10: Rt3000 V3 Installation
The pre-configured settings can also be found in your NAVsuite installation folder; the default installation path is here: C:\Program Files (x86)\OxTS\RT-Range\Survey Trolley\v3 If no v3 folder is present, please make sure that you are using the latest version of RT-Range. The configuration files can be installed using NAVconfig. Physical orientation: 1. -
Page 11: Software Configuration
Software configuration: Only the Orientation, GNSS antenna position, and Displaced output need to be changed. Please see the RT-Range manual for all other settings. A summary of the required changes can be seen in Table 3. Table 3. RT Configuration on the Survey Trolley Changes... - Page 12 Oxford Technical Solutions Ltd Page 11 of 12...