Furniture of America Golva CM7295D Assembly Instructions Manual

CM7295D

ASSEMBLY RATING

The Assembly Rating is a 5-point system that

shows the degree of effort needed in

Allen Wrench

(Included)

assembling a specific product (with 1 being

easy and 5 being difficult). For some

Phillips Screwdriver

products, two persons are recommended.

(Not Included)

DIFFICULT

EASY

2 PERSONS RECOMMENDED

Page 1 of 6

Rev.16-0 9 -05

Table of Contents

Do you have a question about the Golva CM7295D and is the answer not in the manual?

Page 1 Assembly Instructions CM7295D ASSEMBLY RATING Tools Required for Assembly: The Assembly Rating is a 5-point system that shows the degree of effort needed in Allen Wrench (Included) assembling a specific product (with 1 being easy and 5 being difficult). For some Phillips Screwdriver products, two persons are recommended.
Page 2 Page 2 of 6...
Page 3 Before you begin, please read Page 2 of “Assembly and Care Advice”. And remember, do not tighten until each step is completed or instructed. Parts List Hardware List #1 x 1 pc #A x 8 pcs Dresser Bolt 5/16” x 1-3/4” #B x 8 pcs #2 x 4 pcs Flat Washer...
Page 4 #A x 8 pcs #B x 8 pcs #C x 8 pcs Turn right (clockwise) to tighten With the help of another person, carefully place the dresser (#1) on its back over a protected surface. Align the 4 legs (#2) with the pre- drilled holes on the bottom corners of the dresser (#1).
Page 5 #E x 8 pcs #F x 16 pcs #G x 48 pcs Turn right (clockwise) to tighten Prepare the assembly of the knob (#E) to the drawer of the dresser (#1) by using 6 plastic washers (#G) and two screws (#F).
Page 6 SAFETY STRAP TO PREVENT TIP-OVER CABLE TIE BRACKET ANCHOR Attach a bracket (#B) onto the back of the dresser using a Phillips screwdriver to secure it with 2 screws (#E). Drywall: Select a location where you want the dresser to be strapped. Mark on the wall the location where the anchors (#C) will be placed.