No.
Error
7 The ventilation mode
cannot be switched with
the remote controller.
8 When the main power
supply is turned on,
the remote controller
display will indicate and
Lossnay will start.
9 There is no power fail-
ure automatic return.
10 The fan does not stop
even though the remote
controller is set to stop.
11 When PZ-60DR-E is
used, Lossnay starts or
stops operating, or the
fan speed changes, by
itself.
12 When PZ-60DR-E is
used, Lossnay does not
operate in accordance
with the timer setting.
13 "CLEANING" "FILTER"/
"CLEANING" "CORE"
(PZ-60DR-E) continues
to blink and the display
cannot be reset.
Note: When two remote controllers are used, the combination of the PZ-60DR-E and other remote controller cannot
be used.
Cause
The bypass ventilation switching external
input (CN16) is set to ON.
When PZ-60DR-E is used, "RECOVERY
SETTING" is set to " on" or "AUTo" with the
function selection of the remote controller.
When PZ-60DR-E is not used, the function
selection switch (SW2-6 or SW5-4) on the
Lossnay circuit board is set to ON.
When PZ-60DR-E is used, "RECOVERY
SETTING" is set to "oFF" with the function
selection of the remote controller.
When PZ-60DR-E is not used, the function
selection switch (SW5-4) on the Lossnay
circuit board is set to ON.
Operation monitor with delay function is set
to ON. (Function selection switch SW2-8 or
SW5-6 is set to ON)
Timer function has been set with PZ-60DR-E.
"NIGHT PURGE" is set to " on" with PZ-
60DR-E.
When a different timer has been set with
each remote controller in a two remote con-
troller system, the resultant operation will
not be in accordance with the setting.
The display is reset incorrectly.
The remote controller has broken down.
─ 49 ─
Action
Check the bypass ventilation
switching input (CN16). (Refer to
page 27)
Check the power supply ON/
OFF/AUTO setting with the
PZ-60DR-E function selection.
(Refer to page 33)
Check the function selection
switch (SW2-6 or SW5-4). (Refer
to page 30)
Check the power supply ON/
OFF/ AUTO setting with the
PZ-60DR-E function selection.
(Refer to page 33)
Check the function selection
switch (SW5-4) on the Lossnay
circuit board. (Refer to page 30)
Check the function selection
switch (SW2-8 or SW5-6). (Refer
to page 30)
Check the timer function setting
with PZ-60DR-E.
Check the night purge setting of
PZ-60DR-E. If enabled, this is not
an error. (Refer to page 33)
Perform the timer setting with
one remote controller only, and
use the other remote controller
as "(
Timer off indicator)".
During Lossnay operation, press
the "FILTER" button two times
(within 3 seconds).
Replace the remote controller.