Bosch Kiox Original Operating Instructions page 12

external USB power source. Carpeting and other heat insulating sur-
faces block proper air circulation which may cause overheating of the on-
board computer. If smoke or melting of the on-board computer is ob-
served, unplug the external USB power source immediately and do not
use the on-board computer. Contact customer service immediately.
Before each use, check the on-board computer, cable and plug. If
u
damage is detected, do not use the on-board computer. Damaged on-
board computer, charging cables and plugs increase the risk of a fire, ex-
plosion and personal injury.
Do not disassemble on-board computer. No user serviceable part in-
u
side. Incorrect reassembly or damage may result in fire or explosion.
NOTICE: This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions:
1. This device must not cause harmful interference, and
2. this device must accept any interference received, including interfer-
ence that may cause undesired operation.
NOTICE: Changes or modifications made to this equipment not expressly
approved by the Robert Bosch GmbH may void the FCC authorization to op-
erate this equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These lim-
its are designed to provide reasonable protection against harmful interfer-
ence in a residential installation. This equipment generates, uses and can ra-
diate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communica-
tions. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equip-
ment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
Radiofrequency radiation exposure Information: The radiated output
power of the device is far below the FCC radio frequency exposure limits.
Bosch eBike Systems
English – 12
1 270 U20 Ken | (10.12.2021)