Tools And Parts Needed; Preparing For Installation - GE Profile PGP990DEN Installation And Owner's Manual

TOOLS AND PARTS NEEDED

• Large flat-blade screwdriver
• Phillips screwdriver
• 3/8 socket and ratchet
• Saw
• Carpenter's square
• Pipe wrench
• Gas line shut off valve
• Pipe joint sealant for use with gas connections
that resists action of LP gas
For flexible connection where local codes permit:
• Flexible metal tubing (same 3/4 or 1/2 I.D. as gas
supply line)
• Flare union adapter for connection to supply line
(3/4 NPT x 3/4 I.D. or 1/2 NPT x 1/2 I.D.)
• Flare union adapter for connection to regulator
(1/2 NPT x 3/4 I.D. or 1/2 I.D.)
For rigid connection:
• Pipe fittings as required
IMPORTANT
Motor Clearance—Provide 2 min. (5.1 cm) cabinet
clearance to motor for cooling purpose.
NOTE: Where possible, 6 (15.2 cm) is recommended
for motor/blower service.
Side Clearance—Grills installed near a side wall should
allow a minimum clearance of 8 (20.3 cm).
You must allow room enough to remove and empty
grease container(s).
CAUTION: Warranty is void on equipment installed other
than as recommended by GE. Recommended wall
caps and transitions must be used for proper
operation and installation.
Installation Instructions
PREPARATION
20

PREPARING FOR INSTALLATION

Tie down
bolt on
each end
*Blower can be swiveled 90°
Grease Container
29 ± 1 ⁄
16
73.66 ± .16 cm
9 1 ⁄
2
24.13 cm
15 ⁄
16
2.38 cm
Minimum
Clearance
Select appropriate duct
cutout. (See ducting
installation instructions.)
4 3 ⁄
18 1 ⁄
2
47 cm
Minimum
Clearance
2
5.08 cm
Minimum
Clearance
* Blower may be rotated for horizontal or vertical direction by loosening
nuts around blower inlet. Accessible inside ventilation chamber.
Pressure Regulator
Wiring Box Cover
21 ± 1 ⁄
16
53.5 ± .16 cm
9
22.86 cm
1 7 ⁄
14 3 ⁄
16
4.76 cm
36.04 cm
10.64 cm
16
Appliance
Pressure
Regulator
Grease
Container
14 1 ⁄ 12 7 ⁄
2 8
36.83 cm 32.7 cm
Min.
8