Replace The Storage Drawer; Final Installation Checklist; Operation Checklist - GE Profile JS998SKSS Installation Instructions Manual

INSTALL THE RANGE
REPLACE THE STORAGE
13
DRAWER
Place the drawer rail on the guides.
A
Push the drawer in until it stops.
B
Lift the front of the drawer and push in
C
until the stops clear the guides.
D Lower the front of the drawer and push
in until it closes.
SPECIAL INSTRUCTIONS IF YOU ARE
HAVING PROBLEMS WHILE REPLACING
THE STORAGE DRAWER
If Drawer Won't Close:
Drawer does
not close
completely
Power cord may be
obstructing drawer in
this area
Remove and replace, making sure the
power cord is not obstructing the drawer
and/or the rail is in the guide.
If Drawer Is Crooked:
Rear drawer
support is on
top of guide rail
on the high side
Remove and replace, making sure the
rail is in the guide.
Installation Instructions
(cont.)
Stop
Drawer front
panel tipped
away from
body side
Rear drawer support
is resting on top of
guide rail
Drawer front panel
tipped to one side
FINAL INSTALLATION
14
CHECKLIST
• Check to make sure the circuit breaker is
closed (RESET) or the circuit fuses are
replaced.
• Be sure power is in service to the building.
• Check to be sure that all packing materials
and tape on metal panel (if applicable)
under control knobs and drawer have been
removed.
15

OPERATION CHECKLIST

• Push down and turn any one of the four
surface knobs to MED setting to observe
that the element glows within 15 seconds.
Turn the knob off when glow is detected.
If the glow is not detected within the time
limit, recheck the range wiring connections.
If change is required, retest again. If no
change is required, have building wiring
checked for proper connections and voltage.
• Turn on the power to the oven. (Refer to
your Owner's Manual). Verify that the bake
and broil functions make the oven hot by
feeling heat coming off the elements within
20 seconds.
12