Install The Range; Slide Range Into Opening; Final Check Of The Anti-Tip Bracket - GE Profile JS998SKSS Installation Instructions Manual

INSTALL THE RANGE

SLIDE RANGE INTO OPENING

11
Position the range in front of the cabinet
A
opening.
Make sure that the glass that overhangs
B
the countertop clears the countertop.
If necessary, raise the unit by lowering
the leveling legs.
Push while lifting the range into the
C
opening, until the range is within 2"
of engaging the anti-tip bracket.
Remove the protective trim from the side
D
of glass (if provided).
E Using the adjustable pliers or wrench,
carefully screw in the back leveling leg
until the glass overhang comes to rest
on the countertop.
Adjustable wrench
or pliers
F Then carefully screw in the front two
leveling legs (similar to E above) until the
glass overhang touches the countertop.
G Carefully push the range into the opening
until the countertop fully engages the
control panel. The back glass overhang
should cover the cutout opening.
Make sure the edge
of the countertop
fits flush against
the end of the
Front Control Panel
Installation Instructions
Countertop
11
SLIDE RANGE INTO OPENING
11
Plug the range cord into the receptacle.
H
Locate the cord in the back of the range
in a manner that it will not touch or be
moved by the drawer.
Position range cord so that
there is no interference with
the storage drawer
STORAGE DRAWER
FINAL CHECK OF THE ANTI-TIP
12
BRACKET
When installation is
complete and the range is
in place, check to be sure
that the rear leveling leg is
fully inserted into the slot
of the Anti-Tip Bracket.
(cont.)