Panasonic CS-UC12QKD Service Manual page 24

9 Secure the power supply cord and connection cable onto the control board with the holder.
10 Fix back metal cover to original position without damaging aluminium foil. Ensure metal cover is fitted at both
end.
11 Install front grille and tighten front grille to chassis with screw.
Note:
Isolating Devices (Disconnecting means) should have minimum 3.0 mm contact gap.
Ensure the colour of wires of outdoor unit and the terminal Nos. are the same to the indoor's respectively.
Earth wire shall be Yellow/Green (Y/G) in colour and longer than other AC wires as shown in the figure for the
electrical safety in case of the slipping out of the cord from the anchorage.
WARNING
This equipment must be properly earthed.
24