Setting The "Bass Engine; Adjusting Bass Level/Treble Level; Setting The Subwoofer; Adjusting The Subwoofer Level - Alpine iLX-507E Owner's Manual

• If the Subwoofer setting is [Off], the Subwoofer setting cannot
be edited (page 29).
• While adjusting the X-OVER you should consider the
About the
frequency response of the connected speakers.
Calling the X-Over adjusted value
Calling the pre-set X-OVER adjusted value.
Touch [Preset 1], [Preset 2], or [Preset 3].
The setting stored in the Preset will be recalled.

Setting the "bass engine"

You can set your favorite "bass engine" Type.
Setting contents:
Type:
Level:
1
Touch [bass engine].
The "bass engine" setting screen is displayed.
2
Touch [bass engine] to switch the type.
Off
Punch
3
Touch [
then adjust the level.
• When the Defeat setting is [On], you cannot perform the bass
engine.
• The "bass engine" setting screen is returned to the Sound
Setup Menu screen if no operation has been performed for
more than 3 seconds.

Adjusting Bass Level/Treble Level

Setting item:
Bass, Treble
Setting contents:
Bass:
Treble:
Touch [
adjust the level.
• The Bass level and Treble level are reflected in the settings of
Band2 and Band11 in EQ Setting. Depending on settings of
Band2 and Band11 in EQ Setting, the adjustable Bass level
and Treble level are changed.
• When "Bass" and "Treble" are not displayed, touch [Subw.] to
switch to [Tone Adjust] mode.
• Not available when "bass engine" is set.
Off (Initial setting) / Standard / midbass
/ Rich / Lowbass / Punch
0 to 6
Standard midbass Rich Lowbass
Off
] or [ ] of "BASS ENGINE Level," and
-18 to 18 (Initial setting: 00)
-18 to 18 (Initial setting: 00)
] or [ ] of the "Bass" or "Treble," to

Setting the Subwoofer

Touch [Tone Adjust].
The "Subwoofer Level" setting screen is displayed.

Adjusting the Subwoofer Level

You can set the Subwoofer level when a Subwoofer is
connected.
Setting item:
Subwoofer Level
Setting contents:
0 to 15 (Initial setting: 0)
Slide the lever left or right to adjust the level.
• This setting is only available when "Subwoofer" is set to [On]
(page 29).

Setting the Subwoofer Phase

The subwoofer output phase is toggled Subwoofer
Normal (0°) or Subwoofer Reverse (180°).
Setting item:
Phase
Setting contents:
0° (Initial setting) / 180°
Touch [Phase] to switch the subwoofer output
phase.
• This setting is only available when "Subwoofer" is set to [On]
(page 29).

Defeat Setting

If Defeat is [On], Media Xpander, EQ Setting and
"bass engine" functions are turned Off. This disables any
settings made for these functions.
Setting item:
Defeat
Touch [Defeat].
The indicator lights up when Defeat is set to On.
ALPINE iLX-F509E 68-41657Z84-A (EN)
31
-EN