Replacement Of Drive Disc Bearing - Partner K950 RING Workshop Manual

REPLACEMENT OF DRIVE DISC BEARING

506 37 61-01
Tool
Replace the drive disc bea-
ring using tool 506 37 61-01.
Removal
Starting-point
Remove the cutter blade.
Let the drive disc remain in
place.
Water disc
Remove the water disc.
Transmission shroud
Remove the shroud.
Drive belt
Undo the tension roller's
locking screw.
Remove the belt.
Pulley
Press in the rotation catch
and remove the pulley.
Tool
In order to replace the drive disc bear-
ing, it is necessary to use a special
tool produced by Partner. The tool's
part number is 506 37 61-01.
The tool is used both for removal
and for installation of the drive disc
bearing.
Removal
Starting-point
Remove the cutter blade as described
in chapter 4, "Replacement of cutter
blade". Let the drive disc remain in
place.
Water disc
Remove the 4 screws that secure the
water disc.
Pull off the water disc from the hose.
Transmission shroud
Remove the 4 screws that secure the
shroud and take off the shroud.
Drive belt
Undo the tension roller's locking
screw.
Remove the belt.
Pulley
Prevent the pulley from rotating by
pressing in the rotation catch under
the pulley. Remove the centre screw
and take off the pulley.
10
15