Advertisement
•
Do not remove the bucket while the unit is in operation. If the
bucket needs to be emptied, shut off the unit first. Removing
the water bucket while the unit is running may cause electrical
shock or other safety hazards.
•
If you wish to use a hose to continuously drain the device
rather than repeatedly emptying the bucket, refer to the "Drain
Hose" section under Drainage Options (below).
•
All successful button presses on the control panel will be
confirmed with an auditory beep.
•
When the power cable is connected, the indicator light above
the power button will be lit and the dehumidifier will beep to
confirm the connection.
DRAINAGE OPTIONS
MANUAL DRAINING
NOTES: Do not remove the bucket when unit is in operation or has
just stopped. Otherwise it may cause some water to drip on the
floor.
Do not use the hose if using water bucket to collect water. When
the hose is connected, water will be drained out through it instead
of into the bucket.
1. Hold the handles on both sides of the water bucket and pull
it out following the arrow direction. (Attention: Pull out the
bucket carefully to prevent water from spilling out
from the bucket.)
2. Empty the bucket by grasping the handle on the
top of the bucket with one hand and grasping the
bottom of bucket with the other hand.
3. Replace bucket in the dehumidifier according to
the arrow direction.
NOTE: Actual product may be different from above graphics,
please refer to actual product.
DRAIN HOSE
NOTE: No garden hose is included in the box, so you will need to
supply your own. The hose should have a thread with an outer
diameter of 1-1/16" (2.7 cm) and a pitch
of 11.5 TPI.
1. Remove the bucket from the unit as
described in Option 1.
2. Locate a nozzle with threading
inside the compartment where the
bucket sits.
3. Lift the hatch on the outside of the
dehumidifier that allows you to feed
the hose through the opening. Then,
screw the hose into the threading of
8
USAGE
Hide quick links:
Advertisement
