Other Information For This Machine; Laws And Regulations; Legal Requirements - Ricoh IM 2500 Series Safety Information Manual

3. Other Information for This Machine

Laws and Regulations

Duplication and Printing Prohibited
Do not copy or print any item for which reproduction is prohibited by law.
Copying or printing the following items is generally prohibited by local law:
bank notes, revenue stamps, bonds, stock certificates, bank drafts, checks, passports,
driver's licenses.
The preceding list is meant as a guide only and is not inclusive. We assume no responsibility
for its completeness or accuracy. If you have any questions concerning the legality of copying
or printing certain items, consult with your legal advisor.

Legal Requirements

Laser Safety
For IM 2500/2500A/3000/3000A/3500/3500A
This machine complies with the requirements of IEC60825-1:2014 (EN60825-1:2014) for class
1 laser product. This machine contains one AlGaInP laser diode, 660 nanometer wavelength.
The beam divergence angle is 21 degrees (minimum) and 29 degrees (maximum) in the
vertical direction, and 7 degrees (minimum) and 11 degrees (maximum) in the horizontal
direction, and laser beams are generated in Continuous Wave (CW) mode. The maximum
output power of the light source is 10 milliwatt.
The following label is attached on the rear side of the machine:
Caution
Use of controls or adjustments or performance of procedures other than those specified in
this manual might result in hazardous radiation exposure.
For IM 4000A/5000A/6000
This machine complies with the requirements of IEC60825-1:2014 (EN60825-1:2014) for
class 1 laser product. This machine contains two AlGaInP laser diodes, 660 nanometer
wavelength for each emitter. The beam divergence angle is 15 degrees (minimum) and
25 degrees (maximum) in the vertical direction, and 7 degrees (minimum) and 13 degrees
(maximum) in the horizontal direction, and laser beams are generated in Continuous Wave
(CW) mode. The maximum output power of the light source is 15 milliwatt.
The following label is attached on the rear side of the machine:
Caution
Use of controls or adjustments or performance of procedures other than those specified in
this manual might result in hazardous radiation exposure.
13