- [Skip Blank Page]
As each document page is scanned, the scanner detects whether it is blank,
and if so, the image is not saved.
Selecting [Skip Blank Page] enables the [Setting] button, which opens the
[Blank Skip Setting] dialog box.
Adjust the [Content density] setting in the [Blank Skip Setting] dialog box if
blank pages are not skipped, or if non-blank pages are skipped.
The [Content density] setting should be adjusted according to the
document content, so that only blank pages are skipped: increase the
setting if they are not skipped, and decrease the setting if non-blank pages
are skipped.
The Skip Blank Pages function may not work properly if the [Custom]
setting is enabled in the [Gamma Settings] dialog box.
If a scanning side setting (simplex or duplex) is specified in the application
settings, set [Simplex].
- [Folio]
Documents that are normally folded in half are scanned on both sides and
composed into one image.
You cannot click [Folio] if you click [Patchcode] in the [Batch Separation]
box of the [Others] tab.
43
Back
Contents
Correcting Image Skewing
This section describes the procedure for setting the scanner to detect slanted
document pages and straighten the scanned images.
1
In the ISIS/TWAIN driver properties dialog box, click the [Basic] tab →
select the [Deskew] check box.
NOTE
Deskewing SWITCH also may not work properly or cause part of the image to be
lost in other cases, depending on the document.
Previous Page Next Page
DR-2010C / DR-2510C
DR-2010C / DR-2510C