Table of Contents
Advertisement
Troubleshooting
5
Troubleshooting
5.1
General troubleshooting procedure
1. Try to solve the problem with the information in this manual.
See § 5.3.1.
2. If it is not possible to solve the problem with the information in
this manual, contact service. See § 5.3.
5.2
Opening solenoid lock manually.
During power failure, machine doors are locked automatically.
Opening of door is not recommended to ensure operator safety.
To open the door manually option1 is preferable.
Option1: Insert the plate (1.) through the gap for the
top lock as shown (2.), Plate should touch the rod of solenoid
lock as shown (3.), push the rod towards right & at same time
pull the door slightly.
Repeat the same procedure for bottom lock,
door will be fully open
Option2: Holes are provided in front panels
at top and bottom side where solenoids locks positioned.
To access the solenoid lock manually:
1. Remove the plastic plugs (A)
2. Insert the flat end screwdriver through hole 'B' upto
edge 'C' of solenoid rod & pull the rod towards right side.
3. Do it this process simultaneously for both top & bottom
lock & open the door by holding the handle.
5.3
Contact service
1. Find the type plate on the rear of the machine. See § 3.1.5.
2. Take a note of the model number and the serial number of the
machine.
3. Contact your supplier or manufacturer.
See www.fast-fluid.com.
5.4
Error messages and other faults
Note
See the column Possible solution to solve the
problem. When the problem persists, contact
service. See § 5.3.
GX300
24
Advertisement
Table of Contents
