Operation; Fuel Cock; Reversing Starter - Wacker Neuson DS70 Operator's Manual

Item Designation
1 Gas regulating lever
2

Fuel cock

1. Hold the machine at the guidance clip.
2. Open fuel cock.
3. Set gas regulating lever to SLOW.
4. Pull the starter rope several times until the engine starts.
5. Allow the engine to warm up.
6. The machine starts and vibration works in the forward direction.
9.4

Operation

Guide and steer the machine only at the guide clip.
9.4.1 Compacting material
WARNING
Injuries due to an uncontrolled machine.

1. Guide the machine with both hands on the guidance clip.
2. Operate the gas regulating lever until the desired speed is reached.
3. If the material is compressed, lift and reset the machine.
When lifting the machine, set the gas regulating lever to NO LOAD, so that the engine continues

to run at a low speed.
100_0201_op_0005.fm
1
Always hold the machine with both hands and in a firm position.
2
3
Item Designation
3

Reversing starter

9 Use and operation
23